Detroit-radiant-products-company QTD Series Bedienungsanleitung

WARNING!Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, opera

QTD Series10WARNING!Improper installation, adjustment, alteration, service or maintenance can cause property damage, serious injury or death. Read and

QTD Series11Chart 3.1 • Recommended Mounting Heights and CoveragesModel No.Input BTU/h RecommendedMounting Height (ft.)Approximate Coverage Area (LxW)

Heater PackagingHeaters are made up of three pieces shipped in two boxes; the burner control box in the first box and the emitter assembly and reflector

QTD Series133.0 Installation • Heater AssemblyFigure 3.3 • Heater AssemblyAssembly prior to hanging: With this method, the use of two saw horses or a

NOTE: Prior to installing the reflector, relocate the saw horses to support the burner control box and the tubes beneath the u-end reflector. 1 Align t

1 Transfer the heater’s three hanging locations to the ceiling where the unit is to be installed and mark hanging points. 2 Prepare mounting surface

QTD Series163.0 Installation • Hanging Pre-Assembled Unit1 Raise the assembled unit from assembly station to prepared hanging location. NOTE: This c

QTD Series173.0 Installation • Hanging Pre-Assembled Unit • Final Check ListFinal Check List1 Check the unit for level across the length (Figure 3.7)

QTD Series183.0 Installation • VentingVentingWARNING!Insufficient ventilation and/or improperly sealed vents may release gas into the building which co

QTD Series193.0 Installation • Venting • Unvented OperationWhen using an unvented configuration (commercial & industrial use only), consider the fo

QTD Series2Contents1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

QTD Series203.0 Installation • Venting • Sidewall VentingSidewall VentingGuidelines: Vent Pipe Angle • To prevent moisture from entering the he

QTD Series21Vent Termination United States: • Vent must terminate a minimum of 4 ft. (1.2 m) below, 4 ft. (1.2 m) horizontally from, or 1 ft.

QTD Series223.0 Installation • Venting • Rooftop VentingRooftop VentingGuidelines: Vent Locations and Clearances • Separate air intake duct from v

QTD Series233.0 Installation • Venting • Common VentingFigure 3.13 • Common Rooftop Venting - Side ViewCommon Venting • When joining two heaters t

QTD Series243.0 Installation • Combustion Air RequirementsCombustion air may be supplied to the heater by indoor or outdoor means.If using combustion

QTD Series253.0 Installation • Combustion Air Requirements 4 in. 20 ft. 4 in.(single)/6 in.(dual)

QTD Series263.0 Installation • Gas Supply Natural 3.5 Inches W.C. 5.0 Inches W.C. 14.0 Inches W.C. Liquefied Propane 10.0 Inches W.C. 11.0 Inche

QTD Series273.0 Installation • Gas SupplyCAUTION!When using a stainless steel flexible gas connector, do not attach the connector nuts directly to the

QTD Series283.0 Installation • Gas SupplyWARNING!Testing for gas leaks with an open flame or other sources of ignition may lead to a fire or explosion a

QTD Series29The heater must be electrically grounded in accordance with the following codes: United States: Refer to National Electrical Code®, AN

1.0 IntroductionQTD Series3OverviewThe intent of this manual is to provide information regarding general safety, installation, operation and maintenan

QTD Series303.0 Installation • Electrical Requirements • Field WiringWARNING!Electric ShockField wiring to the radiant tube heater must be connected a

QTD Series31Figure 3.22 • Alternate Field Wiring Diagram • Single Unit operation on a Single 24V Control*3.0 Installation • Electrical Requirements •

QTD Series323.0 Installation • Electrical Requirements • Internal Wiring DiagramsBefore field wiring this appliance - Check existing wiring; replace if

QTD Series333.0 Installation • Electrical Requirements • Internal Wiring DiagramsFigure 3.24 • Internal Ladder Wiring Diagram120V/24V TRANSF.BLOWER MO

QTD Series344.0 Operation • Operating Instructions • Start-up and Shutdown Procedures4.0 OperationWARNING!BEFORE OPERATING, smell all around the appli

QTD Series354.0 Operation • Sequence of OperationWARNING!This heater must be installed and serviced by trained gas installation and service personnel

QTD Series36Do both burners light?5.0 MaintenanceTroubleshooting Guide5.0 Maintenance • Troubleshooting GuideTurn up thermostat/controller.Does the fa

QTD Series375.0 Maintenance • Troubleshooting Guide*NOTICEBypassing any switch is intended for testing purposes only. Do not leave switch bypassed du

QTD Series38Troubleshooting ends.5.0 Maintenance • Troubleshooting GuideDo the burners stay on for approx. 15 seconds and then shut off?Continued from

QTD Series395.0 Maintenance • Troubleshooting GuideIf heater does not enter high fire mode, check the following:Is there 24VAC across the red wire on t

WARNING!DETROIT RADIANT PRODUCTS COMPANY21400 HOOVER ROAD - WARREN, MI RE-VERBER-RAY INFRA-RED RADIANT TUBE HEATERFOR INDOOR (Non-Residential) INSTA

QTD Series405.0 Maintenance • Heater Components and Parts ListFigure 5.1 • Burner Assembly ComponentsReplacement PartsPart No. Description Part No. D

QTD Series415.0 Maintenance • Heater Components and Parts List Part No. Description Part No. DescriptionTP-6020B Fan Restrictor Plate - 60 TP- 6074 Si

QTD Series425.0 Maintenance • Routine InspectionPersonal injury or death may result if maintenance is not performed by properly trained gas installer

QTD Series435.0 Maintenance • Limited Warranty Terms and ConditionsLimited Warranty Terms and ConditionsOne-Year Limited Warranty. Radiant Tube Heater

Kit Contents Check List5.0 Maintenance • Kit Contents Check ListChart 5.2 • Kit Contents for QTD SeriesBox Part No. Description QuantityT TP-13 Self D

Right Panel Left PanelF/ N : LLV3EP2NEUTRALEARTHHOT- 120V HEATER INPUT -120VF/ N : LLV3EP1F/N: LLTCL013: Clearance to Combustibles and Gas Data LabelF

Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.Young child

QTD Series7ApplicationsThis is not an explosion proof heater. No radiant tube heater may be used in a Class 1 or Class 2 Explosive Environment. Consul

WARNING!Placement of explosive objects, flammable objects, liquids and vapors close to the heater may result in explosion, fire, property damage, seriou

Model Number Top Sides Below Back EndQTD-60 [N, P]10 36 40 6 12QTD-80 [N, P]10 36 40 6 12Chart 2.1 • Clearance to Combustibles in Inches (see Figure 2