Detroit-radiant-products-company QTS Series Bedienungsanleitung

WARNING!Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, opera

QTS Series10WARNING!Improper installation, adjustment, alteration, service or maintenance can cause property damage, serious injury or death. Read and

Model No.Input BTU/h RecommendedMounting Height (ft.)*Approximate Coverage Area (LxW)*QTS-40 [N,P] 40,000 8 to 10 25 x 35QTS-60 [N,P] 60,000 8 to 12 3

Model Overall Unit Length Suspension Points Shipping Weight Chain Set Qty.QTS-40 [N,P] 103” 3 or 4 103 lbs. 3QTS-60 [N,P] 103” 3 or 4 103 lbs. 3QTS-80

Figure 3.3 • Heater AssemblyAssembly prior to hanging: With this method, the use of two saw horses or a raised table or bench surface is beneficial (th

NOTE: Prior to installing the reflector, relocate the saw horses to support the burner control box and the tubes beneath the u-end reflector. 1 Align t

QTS Series153.0 Installation • Preparing Points for Hanging • Hanging Types1 Transfer the heater’s three hanging locations to the ceiling where the u

QTS Series163.0 Installation • Hanging Pre-Assembled Unit1 Raise the assembled unit from assembly station to prepared hanging location. NOTE: This c

QTS Series173.0 Installation • Hanging Pre-Assembled Unit • Final Check ListFinal Check List1 Check the unit for level across the length (Figure 3.7)

QTS Series183.0 Installation • VentingVentingWARNING!Insufficient ventilation and/or improperly sealed vents may release gas into the building which co

QTS Series193.0 Installation • Venting • Unvented OperationWhen using an unvented configuration (commercial & industrial use only), consider the fo

QTS Series2Contents1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

QTS Series203.0 Installation • Venting • Sidewall VentingFigure 3.11 • Sidewall Venting Requirements Sidewall VentingGuidelines: Vent Pipe Angle

QTS Series21Vent Termination United States: • Vent must terminate a minimum of 4 ft. (1.2 m) below, 4 ft. (1.2 m) horizontally from, or 1 ft.

QTS Series223.0 Installation • Venting • Rooftop Venting*Consult the NFPA ANSI Z223.1 Gas Vent Termination criteria if roof pitch exceeds 9:12.Rooftop

QTS Series233.0 Installation • Venting • Common VentingCommon Venting • When joining two heaters to a common vent, a staggered arrangement or a du

QTS Series243.0 Installation • Combustion Air RequirementsCombustion Air RequirementsCombustion air may be supplied to the heater by indoor or outdoor

QTS Series253.0 Installation • Combustion Air Requirements 4 in. 20 ft. 4 in.(single)/6 in.(dual)

QTS Series263.0 Installation • Gas SupplyChart 3.5 • Manifold PressurePressure Equivalents: 1 Inch W.C. equals .058 oz/sq. in. equals 2.49 mbar.NOTE:

QTS Series273.0 Installation • Gas SupplyCAUTION!When using a stainless steel flexible gas connector, do not attach the connector nuts directly to the

QTS Series28Figure 3.18 • Gas Connection (Approved Flexible Gas Connection) • Control Box Side ViewFigure 3.19 • Gas Connection (Approved Flexible Gas

QTS Series29The heater must be electrically grounded in accordance with the following codes: United States: Refer to National Electrical Code®, AN

1.0 IntroductionQTS Series3OverviewThe intent of this manual is to provide information regarding general safety, installation, operation and maintenan

QTS Series30WARNING!Electric ShockField wiring to the radiant tube heater must be connected and grounded in accordance with national, state, provincia

QTS Series313.0 Installation • Electrical Requirements • Field WiringFigure 3.21 • Alternate Field Wiring Diagram • Multiple Line Unit on a Single 24V

QTS Series323.0 Installation • Electrical Requirements • Internal Wiring DiagramsBefore field wiring this appliance - Check existing wiring; replace if

QTS Series333.0 Installation • Electrical Requirements • Internal Wiring DiagramsFigure 3.24 • Internal Ladder Wiring Diagram1234V1V2NCW (24V IN)S1S2(

QTS Series344.0 Operation • Operating Instructions • Start-up and Shutdown Procedures4.0 OperationWARNING!BEFORE OPERATING, smell all around the appli

QTS Series354.0 Operation • Sequence of OperationWARNING!This heater must be installed and serviced by trained gas installation and service personnel

QTS Series365.0 Maintenance5.0 Maintenance • Troubleshooting GuideContinued on page 38Do both burners light?Troubleshooting GuideTurn up thermostat/co

QTS Series37*NOTICEBypassing any switch is intended for testing purposes only. Do not leave switch bypassed during normal operation or the heater’s b

QTS Series385.0 Maintenance • Troubleshooting GuideContinued from page 36.Troubleshooting ends.Do the burners stay on for approx. 15 seconds and then

QTS Series395.0 Maintenance • Troubleshooting GuideCheck to make sure gas pressure is within minimum and maximum inputs as indicated on the heater’s r

WARNING!DETROIT RADIANT PRODUCTS COMPANY21400 HOOVER ROAD - WARREN, MI RE-VERBER-RAY INFRA-RED RADIANT TUBE HEATERFOR INDOOR (Non-Residential) INSTA

QTS Series40Figure 5.1 • Burner Assembly ComponentsReplacement Parts5.0 Maintenance • Heater Components and Parts ListPart No. Description Part No. D

QTS Series41Part No. Description Part No. DescriptionTP-6020B Fan Restrictor Plate - 60 TP-6069 Port Barb FittingTP-6020C Fan Restrictor Plate - 80 TP

QTS Series425.0 Maintenance • Routine InspectionPersonal injury or death may result if maintenance is not performed by properly trained gas installer

QTS Series435.0 Maintenance • Limited Warranty Terms and ConditionsLimited Warranty Terms and ConditionsOne-Year Limited Warranty. Radiant Tube Heater

Box Part No. Description QuantityT TP-13 Self Drilling Screws for Vent Pipe 9B TP-33B 1/2” Shut-Off Valve (Ball Valve & Inlet Tap) 1T TP-62 #8 - 1

QTS - 80PData on this label is for the model shown on this label. If your heater has been converted, this information is not accurate. Please contac

Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.Young child

Standards, Certifications and Government RegulationsInstallation of this radiant tube heater must conform with all applicable local, state and national

WARNING!Placement of explosive objects, flammable objects, liquids and vapors close to the heater may result in explosion, fire, property damage, seriou

Chart 2.1 • Clearance to Combustibles in Inches (see Figure 2.1)Figure 2.1 • Clearance to CombustiblesWARNING!Failure to comply with the stated cleara